Call Us Now!
Continuous Flow Hot Water Systems in Pottsville & Tweed Shire
TruFlow installs and services continuous flow hot water systems for homes across Pottsville and the Tweed Shire, so you never run out of hot water again.
Reliable Hot Water, Any Time You Need It
Cold showers on a Tweed Shire morning are never fun, especially with a house full of people wanting hot water at the same time. If your tank keeps running out or your old system struggles to keep up, a continuous flow hot water system fixes that for good.
Unlike a storage tank, a continuous flow system heats water on demand. There’s no tank to run dry, no waiting for a reheat, and no guessing how many showers you’ve got left before it turns cold. That makes it a strong fit for busy Pottsville households, holiday rentals along the coast, and homes where hot water demand changes from week to week.
We install and service continuous flow hot water systems across Pottsville and the wider Tweed Shire. Salt air off the coast and hard water in parts of the shire both take a toll on hot water systems over time, so getting the right unit and the right install matters more here than in a lot of areas.
Whether you’re replacing an ageing storage tank or building hot water into a new home, we’ll help you get a system sized right for your household, installed properly, and backed by a licensed local plumber.
Common Hot Water Problems We See
Before you buy, it helps to know what actually goes wrong with these systems and why.
We assess your home and current hot water setup, then quote before any work starts.
We help you choose a continuous flow system sized to your household, whether that sits alongside our electric hot water systems as an alternative.
We disconnect and remove your old system where one exists.
We install and connect the new unit to gas or power, following manufacturer specifications.
We test the system under load to check temperature stability and flow.
We walk you through how to operate and maintain your new system.
Hot Water That Actually Keeps Up
The problems above almost always come down to one thing: the wrong system for the household, or a poor install. Get both right and continuous flow hot water works the way it’s supposed to.
Right-sized for your household
We work out your actual hot water demand first, based on bathrooms, appliances and peak usage, so the unit you get can genuinely keep up rather than guessing at a generic size.
Backed by a licensed local plumber
If something needs adjusting after the install, whether that’s a pressure issue or a temperature setting, you’ve got a local plumber to call, not a call centre.
Positioned properly
Where the unit sits affects pressure and how long hot water takes to reach your taps, so we plan the placement around your home’s layout, not just the easiest spot to install.
Ongoing servicing available
Regular servicing keeps the unit running the way it did on day one and catches small issues before they turn into a system that shuts down or won’t ignite.
Installed to spec
Every unit is fitted to the manufacturer’s requirements, from gas or electrical connection through to ventilation and clearances, so ignition and temperature control work the way they’re designed to.
If your current system is letting you down, we’ll help you get one that doesn’t.
Call TruFlow on 0402 763 247 for a free, no-obligation quote.
Continuous Flow Hot Water Installation
Every continuous flow install starts with getting the sizing right for your household, then fitting it properly so it performs the way it’s meant to.
What's Included
- Assessment of your household’s hot water demand (bathrooms, appliances, peak usage times)
- Supply of a gas or electric continuous flow unit sized to that demand
- Removal and disposal of your old hot water system, where applicable
- Installation to manufacturer specifications, including gas or electrical connection
- Pressure and temperature testing before we sign off
This sits within our wider hot water system services for Pottsville and the Tweed Shire.
How it works
We assess your home and current hot water setup, then quote before any work starts.
We help you choose a continuous flow system sized to your household, whether that sits alongside our electric hot water systems as an alternative.
We disconnect and remove your old system where one exists.
We install and connect the new unit to gas or power, following manufacturer specifications.
We test the system under load to check temperature stability and flow.
We walk you through how to operate and maintain your new system.
This service sits under our wider hot water system work, alongside solar, electric, gas, and heat pump options.
Local considerations: Coastal salt air across Pottsville and the Tweed Coast speeds up corrosion on exposed fittings and outdoor units, so placement and protection matter here more than inland. Many local homes are now 20 or more years old, and older gas and electrical connections sometimes need upgrading to support a continuous flow system properly.
Our guarantee: Every install is backed by our 100% satisfaction guarantee. If something’s not right, we come back and fix it, free of charge.
What NSW Requires for Continuous Flow Hot Water Work
Continuous flow hot water installation isn’t a DIY job. It involves gas or electrical connections, and NSW law is specific about who can carry it out.
Licensed Plumbing and Gas Work
All plumbing and gas fitting work must be carried out under a licensed plumber’s NSW Contractor Licence, per the NSW Plumbing and Drainage Act 2011.
Tempering Valve Compliance
Tempering valves must limit water at bathroom outlets to 50°C or below, under AS/NZS 3500.4.
Licensed Gas and Electrical Connections
Gas connections must be completed by a licensed gasfitter, and electrical connections by a licensed electrician.
Council Approval Where Required
Some replacements or new installations may require Tweed Shire Council Section 68 approval.
We keep every job compliant with these requirements as standard, so you’re not left with a system that fails inspection or voids your insurance.
What Sets TruFlow Apart on Continuous Flow Installs
Picking the right plumber for a hot water install matters as much as picking the right unit. Here’s what you get with TruFlow.
20+
Years Plumbing Experience
One Licensed Trade for the Whole Job
We hold Contractor Licence 290544C, covering plumbing, drainage and gas fitting. That means one licensed tradesperson handles your continuous flow install from the water connection to the gas fit, instead of juggling separate contractors.
Your Property, Fully Covered
We carry $20 million in public liability insurance. If anything goes wrong on your property during the install, you’re covered, not left carrying the risk yourself.
The Same Faces, Every Job
We’re based in Pottsville and work across the Tweed Shire. You get the same uniformed, family-run team on the job, not a rotating cast of subcontractors you’ve never met.
We Stand Behind Every Install
Every continuous flow install is backed by our 100% satisfaction guarantee. If something’s not right after we leave, we come back and fix it, free of charge.
What Pottsville Homeowners Say About Our Hot Water Work
From cold showers to reliable hot water, here’s what customers across the Tweed Shire have to say.
Continuous Flow Hot Water FAQs
How does a continuous flow hot water system work?
A continuous flow system heats water on demand as it passes through the unit, rather than storing it in a tank. When you turn on a hot tap, a flow sensor activates the burner or heating element, which warms the water as it travels through.
Will I ever run out of hot water?
A correctly sized continuous flow system won’t run out the way a storage tank can, since it heats water as you use it rather than drawing down a fixed supply. The key word is correctly sized: a unit that’s too small for your household can still struggle to keep up when several taps run at once.
Do I need gas for a continuous flow system?
No, continuous flow systems are available in both gas and electric options. Gas units need an adequate gas supply and correctly sized gas line, while electric units need sufficient electrical capacity, so your existing setup needs checking before installation.
Why does the water temperature sometimes fluctuate?
Temperature fluctuation is usually caused by more than one tap or appliance drawing hot water at the same time, which can push the unit past its capacity. It can also point to a system that wasn’t sized correctly for the household in the first place.
Can I replace my old storage tank with a continuous flow system?
Yes, switching from a storage tank to continuous flow is a common upgrade. It usually involves removing the old tank, connecting the new unit to your existing gas or electrical supply, and confirming the pipework and connections meet current requirements.
Does distance from the unit to the bathroom or kitchen matter?
Yes, the further hot water has to travel from the unit to the tap, the longer it takes to arrive and the more it can affect pressure. This is worth factoring in when deciding where a new unit is installed.
Ready for Hot Water That Doesn’t Let You Down?
Cold showers and lukewarm surprises aren’t something you should have to live with. A properly sized, properly installed continuous flow system fixes that for good, and keeps your household in reliable hot water no matter how many taps are running.
We’re a licensed, insured local plumber based in Pottsville, covering continuous flow installs across the Tweed Shire. Licence 290544C covers plumbing, drainage and gas, so one team handles the whole job.
Get in touch for a free, no-obligation quote and we’ll help you find the right system for your home.
Continuous Flow Hot Water Across Pottsville & the Tweed Shire
We install and service continuous flow hot water systems for homes right across Pottsville and the wider Tweed Shire.
Suburbs & Areas We Service
Pottsville
Hastings Point
Cabarita Beach
Bogangar
Casuarina
Kingscliff
Cudgen
Nunderi
Beyond these, we regularly service Clothiers Creek, Cabarita Beach, Ocean Shores and the wider Tweed Shire. Not sure if we cover your street? Give us a call and we'll confirm.
Email: [email protected]
Phone: 0402 763 247
Address: 213 Overall Drive, Pottsville NSW 2489
TruFlow Plumbing Service
ABN: 37 789 436 603
Quick Links
© 2026 TruFlow Plumbing Service - All rights reserved.
Powered by Action Digital